The fully controllable color change TIX404 underwater light delivers the greatest range of colors and offers a powerful 7,500 verified fixture lumens and an ultra-wide 110° beam angle for the ultimate halo-effect.
Control colors, modes & special effects directly from your MFD and/or the optional Lumishore Display.
All Lumishore Thru-Hulls are ‘flush-fit’ with extremely low profiles. TIX models have the added benefit of an internal LED array and integrated driver, for the ability to service from inside the hull and to simplify installation.
Features
- Full Color – Full Color
- 7,500 Fixture Lumens
- 110° Beam Angle
- Warranty
Specifications
| Specification | Value |
|---|---|
| Available LED Colors | EOS Full Color Change |
| Lumens | 16,875 |
| Verified Fixture Lumens (White) | 7,500 |
| Number and Type of LED | White–12×10W / Green–12×3W / Blue–12×3W / Red–16×3W |
| LED Power – Hicob Array | Yes |
| Typical LED Life | 50,000+ Hours |
| Beam Angle (Degrees) | 110° |
| Driver | Multi-Channel Internal Driver |
| Supply Voltage | 12/24 V DC |
| Max Current Draw (12/24) | 5.8/2.9A |
| Housing Type | Marine Grade Aluminum Bronze |
| User Control Options | From your MFD and/or optional Lumishore Display |
| Lights Synchronized | Yes |
| Color Cycle | Yes |
| Color Cycle w/SPEED Adjust | Yes |
| Color Sweep w/SPEED Adjust | Yes |
| Customizable Favorites | Yes |
| Fixed Strobe (2-Speed) | Yes |
| WI-FI Control (APP) | Yes |
| SOUND-TO-LIGHT | Yes |
| Brightness Adjust | Yes |
| Auto Light Discovery & Setup | Yes |
Downloads
FAQs
It specifies using only 3M 4200, and also notes using “3M 4200 Marine (recommended) or similar” for the sealant bead.
Attach the vessel’s bonding protection to the bonding bolt on the locking ring.
No. The guide warns not to attempt installation or removal with the vessel in the water.
Install it about 6–10 inches (150–250 mm) below the minimum load waterline / water line.
The guide lists a 57 mm (2.25 in) hole size for TIX 40, or 64 mm (2.5 in) with a Delrin sleeve.
Do not expose the lights to temperatures above 150°F (65°C). Avoid mounting near hot engine components or where exhaust emissions could reach the light.
Yes. The guide says all power connections must be made waterproof using a suitable junction box or waterproof connectors.
No. The guide explicitly says not to remove the cartridge; doing so invalidates the warranty and may damage the LED module.
Do not over-tighten. After curing, re-tighten with a force less than 3Nm per bolt (and do not exceed 3Nm).
Yes. Use a suitable fuse or circuit breaker to protect the system, and each light should be individually fused.
The guide states an isolation sleeve kit is required for wood, metal, or carbon fibre hulls; in that case, do not bond the lights.
For best results, space the lights between 2.5 ft (0.8 m) and 6.5 ft (2 m) apart.
Small levels of condensation can occur on rare occasions; the guide states this is normal for high power LEDs and will disappear after cooling.
Contact the SailRACE team — as certified marine experts we’re happy to help with product selection, installation and after-sales servicing, before and after your purchase.
