This fully controllable color change TIX1604 underwater light delivers the greatest range of colors, 17,500 verified fixture lumens and an ultra-wide 110° beam angle for the ultimate halo-effect.
Control colors, modes & special effects directly from your MFD and/or the optional Lumishore Display.
TIX models have the added benefit of an internal LED array and integrated driver, for the ability to service from inside the hull and to simplify installation.
Features
- Full Color – Full Color
- 17,500 Fixture Lumens
- 110° Beam Angle
- Warranty
Specifications
| Specification | Value |
|---|---|
| Available LED Colors | EOS Full Color Change (Rgbw) |
| Lumens | 39,375 |
| Verified Fixture Lumens (White) | 17,500 |
| Number and Type of LED | White – 36 x 10W, Green – 36 x 3W, Blue – 36 x 3W, Red – 48 x 3W |
| LED Power – Hicob Array | Yes |
| Typical LED Life | 50,000+ Hours |
| Beam Angle (Degrees) | 110° |
| Driver | Multi-Channel External Driver |
| Supply Voltage | 24 V DC |
| Max Current Draw | 6.5A |
| Housing Type | Marine Grade Aluminum Bronze |
| User Control Options | From your MFD and/or optional Lumishore Display |
| Lights Synchronized | Yes |
| Color Cycle w/SPEED Adjust | Yes |
| Color Sweep w/SPEED Adjust | Yes |
| Customizable Favorites | Yes |
| Fixed & Random Strobes | Yes |
| Programmable Scenes | Yes |
| WI-FI Control (APP) | Yes |
| SOUND-TO-LIGHT | Yes |
| Brightness Adjust | Yes |
| Auto Light Discovery & Setup | Yes |
Downloads
FAQs
Yes. The guide warns to ensure correct polarity; incorrect polarity/installation can invalidate the warranty.
The tools list specifies marine sealant and notes to use only 3M 4200.
Disconnect or isolate the vessel power source and battery before starting installation.
No. Do not switch the lights on while covered; wait until covers are removed.
Install it below the minimum load waterline. The guide recommends 6″–10″ (150–250mm) below the minimum load waterline.
No. The guide warns not to install or remove the light when the vessel is in the water.
No. The mechanical planning section says not to remove the cartridge; doing so can invalidate the warranty and damage the LED module.
Yes. Use a suitable fuse/circuit breaker and fuse each light individually.
Bonding is recommended for galvanic protection, but the guide also notes that when using an isolation sleeve kit you should NOT bond the lights.
Yes, the power cable can be extended, but the guide says to use the correct cable gauge.
Do not overtighten. The guide says a force of 3Nm on each bolt should not be exceeded.
Contact the SailRACE team — as certified marine experts we’re happy to help with product selection, installation and after-sales servicing, before and after your purchase.
