Control the boat remotely using the OnDeck™ hub and the relay switch. Add up to five switches to the OnDeck hub to stay in control. Check that the input power of the OnDeck hub works between 15.6 and 31.2 V DC to ensure compatibility with your system.
FAQs
A 1 Amp fuse should be installed on all relay controls at the positive input to the power source. The relay’s positive control (black) wire must connect through this fuse.
All connections must use proper electrical connectors, and bare wire connections exposed to moisture should be watertight. Use heat-shrink type butt connectors or other water-tight connections. If wire extension is needed, use a minimum of 24 AWG (0.08 mm²) wire.
Always disconnect the vessel’s power supply before installation. Wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
Relay switches must be set up in the ActiveCaptain app after installation for remote control.
Install the relay switch and connected devices in a dry area. Do not expose to water or mount where flooding may occur.
You must mount the device where it will not be submerged. For optimal performance, mount above the waterline and in a dry, ventilated area.
The relay’s positive control (black) wire connects through a 1 Amp fuse to the positive side of the same power source as the GTB 10 device. Make sure relay and black box share the same positive source.
Each relay control wire is rated for up to 1 A. For higher-current loads, external relay switches are required. Do not connect these wires to the positive side of a power source.
Mount at least 102 mm (4 in.) from cables and other potential sources of interference for optimal performance.
Mount the relay switch in a location that is dry and not exposed to extreme temperatures, with adequate ventilation, and at least 102 mm (4 in.) from cables and interference sources.
Connect the positive wire from the item’s power cable to the relay’s negative load (blue) wire, and connect the relay’s positive load (yellow) wire to the positive terminal of the item’s power source.
Contact the SailRACE team — as certified marine experts we’re happy to help with product selection, installation and after-sales servicing, before and after your purchase.
Need help confirming compatibility?
Email [email protected] with the product you want to purchase and the make, model and reference of the equipment where it will be installed. Our team will check the available information and reply as soon as possible.