In the box
- Pump assumbly
- Installation instructions
- Installation mounting hardware
- 3 pcs of ORB-5 to 3/8″ compression marine tube fitting
- Note: all other hydraulic fittings, tees and hoses must be sourced separately
FAQs
The pump must not be installed with an unvented reservoir as it can be damaged. Verify the reservoir is vented before installation.
The pump must be installed in a dry location, protected from water and the weather. You should mount the pump horizontally, if possible. If you cannot mount the pump horizontally, you must mount it vertically with the pump head connectors facing up.
For installs with uneven rudder loads causing gradual drift, you can install a check valve accessory to block the bleed down path during manual steering.
No more than 3 m (10 ft.) of hydraulic hose should connect the pump to the cylinder for optimal performance.
Apply a marine corrosion inhibitor spray to the pump body and manifold, and re-apply once each year to extend the life of the pump.
Yes, you must bleed all air from each part of the hydraulic system before using the autopilot to steer the boat.
It is important to wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. Also, always check the opposite side when drilling to avoid damaging the vessel. Installation should be performed by a qualified marine installer familiar with steering and electrical systems.
The cables from the pump to the ECU cannot be extended, so plan the installation location accordingly.
Apply marine corrosion inhibitor spray to the pump body and manifold, and re-apply it yearly to extend pump life.
The pump must be installed in a dry location, protected from water and weather, to avoid damage.
Contact the SailRACE team — as certified marine experts we’re happy to help with product selection, installation and after-sales servicing, before and after your purchase.
